===PCM DTC P1000-70===
Code: P1000 - On-Board-Diagnose-System (OBD): Bereitschaftstest nicht abgeschlossen

Status: 
 - DTC vorhanden zum Zeitpunkt der Anfrage
 - Fehlfunktions Indikator Lampe ist AUS für diesen DTC
 - Test nicht abgeschlossen

Modul: Motorregelungs-Modul

Diagnose Fehler Code Details

Check of all systems is not complete since last memory clear.

--Possible Causes--
	- The vehicle is new from the factory and has not yet been through a complete OBD Drive Cycle.
	- The battery or PCM has been disconnected.
	- An OBD monitor failure had occurred prior to completion of an OBD Drive Cycle.
	- The PCM DTCs have been cleared as part of a service process.

Note: The only way P1000 can be cleared (removed) from memory is when all of the OBD monitors have been successfully completed during normal vehicle operation.

P1000 cannot be cleared from the PCM when: 1. The thermostat is stuck open and a DTC is not generated. 2. There is an open VSS circuit and a DTC is not generated. 3. If the vehicle has a Power Take Off (PTO), the circuit is shorted to VPWR or B+, or the PTO is ON during Self-test.

The purpose of the Diagnostic Trouble Code DTC P1000 is to indicate that not all of the On Board Diagnostics OBD monitors have yet been successfully completed.  You may also refer to the OBD Drive Cycle defined under the Powertrain Control/Emission Diagnosis Manual-Diagnostic Methods or the Owner's Manual.

Remember: It is not necessary to remove P1000 from the Powertrain Control Module PCM by driving the vehicle.

===END PCM DTC P1000-70===

===OBDII DTC Nichts===
Erfolgreiches DTC auslesen, keine Fehlermeldungen gefunden

Modul: On Board Diagnose II

===END OBDII DTC Nichts===

===CSM DTC B2159===
Code: B2159 - Ausgangssignal - Zentralverriegelung an Transponder: Stromkreis kurzgeschlossen nach Masse

Modul: Sicherheitsmodul

Diagnose Fehler Code Details

Ausgangssignal - Zentralverriegelung an Transponder: Stromkreis kurzgeschlossen nach Masse

===END CSM DTC B2159===

===ECS DTC Nichts===
Erfolgreiches DTC auslesen, keine Fehlermeldungen gefunden

Modul: Elektronischer Crash-Sensor

===END ECS DTC Nichts===

===ABS DTC Nichts===
Erfolgreiches DTC auslesen, keine Fehlermeldungen gefunden

Modul: Antiblockier-Bremssystem

===END ABS DTC Nichts===